Crunch Ground Pounder GPV1100.2 Spécifications télécharger pdf (Page 4)

AMPLIFIER FEATURE DESCRIPTIONS

GROUND POUNDER GPV AMPLIFIERS:

Each model is capable of 4 & 2-Ohms stereo per channel, or 4-Ohms mono bridged operation except All Crunch amplifiers feature a comprehensive diagnostic system, with speaker lead short circuit, and

amplifier DC faults indicated by the red “PROTECT” LED.

the mono amps which are capable of 4, 2 and 1-Ohm loads.

CAUTION: DO NOT OPERATE ANY AMPLIFIER BELOW THE INTENDED IMPEDANCE. YOU

The input sensitivities for rated output powers are variable from 0.2 volts to 5 volts on multi channel

WILL CAUSE DAMAGE TO THE AMPLIFIER THAT WILL NOT BE COVERED UNDER THE

models and 0.2 volts to 6 volts on mono models.

All crossovers are fully variable in their respective ranges.

WARRANTY PRINTED IN THE BACK OF THE MANUAL. 2 & 4 Channel amps are capable of 4

Crossover filters are 12dB/Octave.

and 2-Ohms wired stereo and 4-Ohms wired mono bridged. The mono amps are capable of 4, 2

A POWER LED indicates the powered up and turned on condition

and 1-Ohm.

The X-OVER slide switch selects the internal crossover functions:

-The input signal is routed directly to the LINE OUT RCA jacks, regardless of the X-OVER setting

simplifying daisy chaining of amplifiers.

-HPF: Selects the built in HIGH PASS filter, variable from 60 Hz to 1.2kHz.

-FULL: Bypasses all crossovers for full frequency range operation.

-LPF: Selects the built in LOW PASS , variable from 30 Hz to 250Hz.

MODE: The mode switch allows you to choose Stereo for full range 2 channel operation or MONO

for bridging operation

HIGH INPUT: If your radio/CD player does not have unbalanced (RCA) outputs, you can use the

HIGH level (wire) inputs.

LINE INPUT: The line input accepts unbalanced (RCA) inputs from 0.2V to 5V.

LINE OUTPUT: The line output passes through signal from the line inputs which allows you to daisy

chain multiple amplifiers from one signal.

Note that the LOW PASS signal is MONO.

-In the LPF position, the HIGH PASS filter acts as a subsonic

filter.

-When the LPF mode is selected, a 0 to +9dB, at 45Hz, BASS -

EQ is also switched in.

GPV800.2 / GPV1100.2 / GPV3500.2 2-CHANNEL AMPLIFIERS

The 4 channel amps have the same features as the 2 channel models accept that there are 2 sets of

controls.

1 set for channels 1 & 2 and 1 set for channels 3 & 4.

In addition, the 4 channel models have a Mode switch which allows you to select 2, 3 or 4 channel

operation.

The X-OVER slide switch selects the internal crossover functions:

-The input signal is routed directly to the LINE OUT RCA jacks, regardless of the X-OVER setting

simplifying daisy chaining of amplifiers.

-HPF: Selects the built in HIGH PASS filter, variable from 60 Hz to 1.2kHz.

-FULL: Bypasses all crossovers for full frequency range operation.

-LPF: Selects the built in LOW PASS , variable from 30 Hz to 250Hz.

MODE: The mode switch allows you to choose Stereo for full range 2 channel operation or MONO

for bridging operation

HIGH INPUT: If your radio/CD player does not have unbalanced (RCA) outputs, you can use the

HIGH level (wire) inputs.

LINE INPUT: The line input accepts unbalanced (RCA) inputs from 0.2V to 5V.

LINE OUTPUT: The line output passes through signal from the line inputs which allows you to daisy

chain multiple amplifiers from one signal.

Note that the LOW PASS signal is MONO.

-In the LPF position, the HIGH PASS filter acts as a subsonic

filter.

-When the LPF mode is selected, a 0 to +9dB, at 45Hz, BASS -

EQ is also switched in.

GPV1200.4 / GPV1800.4 / GPV2400.4 4-CHANNEL AMPLIFIERS

-The LINE INPUT signal is routed directly to the LINE OUT RCA jacks, regardless of the X-OVER

setting simplifying daisy chaining of amplifiers.

-SUBSONIC: Allows you to adjust the crossover filter from 15Hz to 55Hz.

-LPF: Allows yo to adjust the LOW PASS crossover filter from 40Hz to 150Hz.

LEVEL: Adjusts the input sensitivity from 0.2 volts to 6 volts.

BASS EQ: The Bass EQ is adjustable from 0db to 9dB.

REMOTE: This is the input jack for the remote Level control.

LINE INPUT: The line input accepts unbalanced (RCA) inputs from 0.2V to 6V.

LINE OUTPUT: The line output passes through signal from the line inputs which allows you to daisy

chain multiple amplifiers from one signal.

The mono amps are capable of 4, 2 & 1-Ohm loads.

Operating the amp below 1-Ohm can cause damage to the

amp not covered in the warranty.

GPV2100.1 1-CHANNEL A/B CLASS MONO BLOCK AMPLIFIERS

+ - gnd - +

HI INPUT

5V 0.2V 0dB 9dB 60Hz 1.2KHz 30Hz 250Hz

LEVEL BASS EQ HPF LPF

FULL LPF HPF MONO STEREO

X-OVER MODE

LINE OUT LINE INPUT

LINE INPUT

LINE OUT

CH3/4 CH1/2

CH3 CH4

CH1 CH2

CHANNEL 1 / 2

CHANNEL 3 / 4

+ - gnd - +

HI INPUT

5V 0.2V 0dB 9dB 60Hz 1.2KHz 30Hz 250Hz

LEVEL BASS EQ HPF LPF

FULL LPF HPF

X-OVER

5V 0.2V 0dB 9dB 60Hz 1.2KHz 30Hz 250Hz

LEVEL BASS EQ HPF LPF

FULL LPF HPF

X-OVER

CHANNEL

2 3 4

MODE

FLASH

NO FLASH

FLASH

NO FLASH

FLASH

NO FLASH

BASS BOOST SUBSONIC LOWPASS LEVEL

0dB 9dB 15Hz 55Hz 40Hz 150Hz 6V 0.2V

LINE OUT LINE INPUT

POWER

PROTECT

REMOTE

CONTROL

1 2 3 4 5 6 7 8 9 ... 14 15

Commentaires sur ces manuels

Pas de commentaire

Crunch Ground Pounder GPV1100.2 Spécifications Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Amplificateurs audio pour voitures Crunch Ground Pounder GPV1100.2